服務熱線:
400-879-1999
欄目導航
聯系我們
服務熱線
400-879-1999
電話:400-879-1999
地址:山東省萊州市206國道與308省道交叉口東南50米
當前位置:首頁 > 攪拌車資訊 > 新聞資訊 > 混凝土攪拌機攪拌葉的安裝注意事項
混凝土攪拌機攪拌葉的安裝注意事項
來源:http://www.wtiqradio.com發布日期:2020-07-08   瀏覽量:
 
一:安裝注意事項
1: Installation precautions
1.混凝土攪拌機的攪拌葉的傾角要一致,不能裝反;
1. The inclination angle of the mixing blade of the concrete mixer should be consistent and can not be installed in reverse;
2.攪拌葉傾角過大或過小都會影響攪拌產量,所以葉片與攪拌軸線的傾角在70度或80度左右即可;
2. Too large or too small inclination angle of the mixing blade will affect the mixing output, so the inclination angle between the blade and the mixing axis is about 70 or 80 degrees;
3.攪拌葉的較佳角度是旋轉至上部露出泥料20-30mm;
3. The better angle of the mixing blade is to rotate the upper part of the blade to expose the mud 20-30mm;
4.兩根軸上攪拌葉的相位應與漆相對會在時的相位錯開90度;
4. The phase of mixing blades on the two shafts should be staggered by 90 degrees from the phase when the paint is opposite to each other;
5.安裝攪拌葉時一定要上緊,應盡量上緊攪拌葉上的頭一個螺母;
5. When installing the mixing blade, be sure to tighten the first nut on the mixing blade as much as possible;
中科混凝土攪拌車
二:修理
2: Repair
混凝土攪拌機攪拌葉損壞主要原因有:
The main reasons for the damage of mixing blades of concrete mixer are as follows:
1.葉片磨損,這時候需要割炬把葉片磨損的邊緣斜口割齊,然后用和葉片厚度相同的鋼板切割成需要的尺度補焊到葉片殘體上;
1. The blade is worn. At this time, it is necessary to cut the beveled edge of the worn blade with the cutting torch, and then use the steel plate with the same thickness as the blade to cut into the required scale and weld it to the blade residue;
2.葉柄彎曲或折斷,造成這兩種情況的原因有:
2. The petiole is bent or broken, which is caused by the following reasons
(1)葉柄強度不夠,這時加大葉柄直徑,用圓鋼加工;
(1) When the strength of petiole is not enough, the diameter of petiole should be increased and processed with round steel;
(2)葉柄材質較脆,這時可改為普通圓鋼。
(2) The material of petiole is brittle, so it can be changed into ordinary round steel.
?

萊州中科聚峰機械有限公司
電話:15053524111 地址:山東省萊州市206國道與308省道交叉口東南50米
聚峰機械專注生產銷售混凝土全自動攪拌車,小型混凝土自動攪拌車,自進料混凝土攪拌車,平口攪拌車,廠家直銷,型號齊全,經久耐用,質優價廉;以規范的管理為依托,以專業的技術為支持,安全可靠,讓您放心選擇!

日本无吗无卡v免费清高清